Steinberg WaveLab Elements 7 Manual Pagina 377

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 428
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 376
12.28 Stereo Delay 363
12.28 Stereo Delay
StereoDelay has two independent delay lines with freely specified delay time settings.
The following parameters are available:
Delay 1 & 2
Using these controls you specify the base note value for the delay time in milliseconds.
Sync button
The buttons below the Delay knobs are used to turn tempo sync on or off for the re-
spective delay.
Feedback 1 & 2
The Feedback controls set the number of repeats for each delay.
Filter Lo 1 & 2
These filters affect the feedback loop and allow you to roll off low frequencies up to
800Hz. The buttons below the knobs activate/deactivate the filter.
Filter Hi 1 & 2
These filters affect the feedback loop and allow you to roll off high frequencies from
20kHz down to 1.2kHz. The buttons below the knobs activate/deactivate the filter.
Pan 1 & 2
These controls are used to set the stereo position for each delay.
Mix 1 & 2
Use these controls to set the level balance between the dry signal and the effect. If
StereoDelay is used as a send effect, set them to the maximum value (100 %) as you
can control the dry/effect balance with the send.
Note that the delay can also be controlled from another signal source via the side-chain input.
When the side-chain signal exceeds the threshold, the delay repeats are silenced. When the
signal drops below the threshold, the delay repeats reappear.
Related topics
Audio Plug-ins
Master Section
How do I add effects?
Presets
WaveLab 7
Vista de pagina 376
1 2 ... 372 373 374 375 376 377 378 379 380 381 382 ... 427 428

Comentarios a estos manuales

Sin comentarios