Steinberg WaveLab Elements 7 Manual Pagina 337

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 428
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 336
12.1 Audio Input 323
Leveler
Leveler Multi
Peak Master
Silence
Stereo Expander
Dithering plug-ins
Internal Dithering
12.1 Audio Input
The Audio Input is a special Master Section plug-in that allows you to render a signal coming
in to a sound card's input(s) together with any Master Section effects. This signal can be
anything your sound card accepts, for example a feed from a mixer, a recorder or a micro-
phone.
By default, this plug-in is located in the ASIO sub-menu of the Master Section effects. An
ASIO driver must be used, and only one instance of this plug-in is allowed in the Master
Section plug-in chain.
To use the External gear plug-in, proceed as follows:
1. Set the Audio Device to ASIO
You can access this dialog from Workspaces that support the recording of Audio Files by
choosing Options > Audio Streaming Settings.... Set the Audio Device to "ASIO".
2. Assign the Device Input channels
From the Recording tab, select the channels to be used for device input and name them for
use in WaveLab. Note that you only have to set the ASIO inputs the ASIO outputs are not
relevant for Audio Input. Press "OK" when you are done.
3. Set options for the Audio Input plug-in
Click in the top Master Section effect slot and select "Audio Input" from the ASIO plug-in
sub-menu. The Audio Input control panel opens and you can set the following options:
"Num.Inputs" Using the slider, set this to the number of inputs assigned in step 2.
"Samp.Rate" Using the slider, set this to the sampling rate required (from 11025 to
19200Hz).
4. Monitor the Audio input
WaveLab 7
Vista de pagina 336
1 2 ... 332 333 334 335 336 337 338 339 340 341 342 ... 427 428

Comentarios a estos manuales

Sin comentarios