
12.16 Steinberg GEQ-10/GEQ-30 347
12.16 Steinberg GEQ-10/GEQ-30
(GEQ-10 pictured)
These two graphic equalizers are identical in every respect except for the number of available
frequency bands (10 and 30 respectively). Each band can be cut or boosted by up to 12dB,
allowing for fine control of the frequency response. In addition there are several preset modes
available which can add "color" to the sound of the GEQ-10/GEQ-30.
You can draw response curves in the main display by click-dragging with the mouse. Note
that you have to click on one of the sliders first before dragging across the display. You
can also point and click to change individual frequency bands, or enter values numerically by
clicking on a gain value at the top of the display.
At the bottom of the window the individual frequency bands are shown in Hz. At the top of
the display the amount of cut/boost is shown in dB.
Apart from the frequency bands, the following parameters are available:
Output
Controls the overall gain of the equalizer.
Flatten button
Resets all the frequency bands to 0dB.
Range
Allows you to relatively adjust how much a set curve cuts or boosts the signal. If the
Range parameter is turned fully clockwise, the range is +/-12dB.
Invert button
Inverts the current response curve.
Mode pop-up menu
The filter mode set here determines how the various frequency band controls interact
to create the response curve, see also below.
WaveLab 7
Comentarios a estos manuales