Steinberg WaveLab Elements 7 Manual Pagina 375

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 428
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 374
12.26 Steinberg Roomworks 361
Attack
The envelope settings in RoomWorks control how the reverb will follow the dynamics
of the input signal in a fashion similar to a noise gate or downward expander. Attack
determines how long it takes for the reverb to reach full volume after a signal peak (in
milliseconds). This is similar to a pre-delay but the reverb is ramping up instead of
starting all at once.
Release
Determines how long after a signal peak the reverb can be heard before being cut off,
similar to a gate's release time.
Output
Mix
Determines the balance of dry (unprocessed) and wet (processed) signal. When
RoomWorks is used as an insert for an FX channel, you will most likely want to set
this to 100% or use the Send button.
Wet only button
This button defeats the mix parameter, setting the effect to 100% wet or affected signal.
This button should normally be pressed when RoomWorks is being used as a send
effect for an FX or group channel.
Efficiency
Determines how much processing power is used for RoomWorks. The lower the value,
the more CPU resources will be used, and the higher the quality of the reverb. Inter-
esting effects can be created with very high Efficiency settings (>90%). Experiment for
yourself.
Export button
Determines if during audio export RoomWorks will use the maximum CPU power for the
highest quality reverb. During export you may wish to keep a higher efficiency setting
to achieve a specific effect. If you want the highest quality reverb during export, make
sure this button is activated.
Output meter
Indicates the level of the output signal.
Related topics
Audio Plug-ins
Master Section
How do I add effects?
Presets
WaveLab 7
Vista de pagina 374
1 2 ... 370 371 372 373 374 375 376 377 378 379 380 ... 427 428

Comentarios a estos manuales

Sin comentarios